High efficiency amber light X-LED, max output of 176LM/W, lifetime up to 50000 hours.
15m (16.4yd)/24m (26.2yd)
1 x 18650 rechargeable Li-ion battery (not included)
Tail cap switch (up to 50,000 presses)
73.5±0.5 grams (without battery)
Features: Aerospace Aluminum Alloy construction; black hard anodization (HA) PMMA Lens High efficiency amber light X-LED, max output of 176LM/W, lifetime up to 50,000 hours Lead-free circuit board Constant Current Circuit, maintain same output throughout use Reverse Polarity Protection Low Voltage Warning Over-Discharge Protection No PWM, no circuit noise High light transmission PMMA lens Anti-slip, anti-roll design Wear resistant threads Flashlight body features conductive surface Gold-plated springs 1 meter impact resistance IP67 water resistance rating Individually serialized
Directions: Open the tail cap by twisting counter-clockwise, insert a charged quality 18650 Li-ion battery with the positive terminal towards the bezel, and tighten the tail cap by turning clockwise. The flashlight has Reverse Polarity Protection, the light will not be damaged by batteries inserted in the wrong orientation, but it will not turn on. If this occurs, please check the battery orientation. Half press the tail switch to turn on the flashlight, loose to turn off. Each time the flashlight is turned on, the default setting is "LOW". When the flashlight is on, half press the tail switch to cycle between LOW and HIGH output. Fully press the tail switch until "click" is heard to lock the mode and fully press the tail switch again to turn off the flashlight. When the battery voltage is too low, the flashlight will flash 2 time as a warning. After the first flash warning, the flashlight will operate for approximately 5 minutes as a safety measure. After 5 minutes, the second flash warning. After this warning, the flashlight will shut off automatically.
Notes: Unauthorized disassembly may damage the flashlight and void the warranty. Weltool "Total Heat Dissipation" technology will dissipate the internal heat of the light during operation, it is normal to feel the flashlight body temperature rise. Please check and replace the O-ring regularly to maintain the waterproof rating Please check and lubricate the threads regularly with professional lubricant. Clean the contact surfaces regularly to keep the flashlight normal operation. If irregular strobe or failure to turn-on occurs, the contact surfaces may be dirty and requires cleaning by using alcohol cotton swabs. Remove the battery from the flashlight during long term storage. This flashlight is not intended to be used as a diving light Do not aim the flashlight directly at eyes. Keep out of the children.
Package Included: 1XWeltool M7-AM LED Flashlight 1XPocket clip 1XO-ring