Remote control distance: 10-30 meters (no interference in open space), this distance is the theoretical distance without interference, and it will be reduced according to different environmental disturbances and partition walls.
Number of control channels: 1 way normally open (normally closed) contact
The 12V single-channel learning code remote control switch is suitable for electrical control circuits such as anti-theft alarm, remote control electric door and window, signal control, industrial control, lifting equipment and the like.
Remote control switch module relay contact independent output, very suitable for direct control of various loads;
The product adopts learning code wireless coding technology (space-to-space pair code), no directionality, and the switches do not interfere with each other.
12V remote control switch, the power supply is recommended to use more than 500mA DC regulated power supply. Working mode: self-locking/interlocking/jogging user can adjust freely, which can realize one control/multiple control one.
The receiver board can withstand 10A per channel and can directly drive DC/AC loads, each with a set of normally open (normally closed) contacts.
In order to extend the service life of the receiving board, not recommend controlling the high-power load. When controlling 220V, each control is less than 500W, and when controlling 12V, each control is less than 500W.
1. Output relay switching: can control the load of different voltages below 250V. The power supply must be 12V.
2. Small volume: small size, circuit board size is only 35 * 32 * 19mm.
3. Working mode can adjust at will: adjust the self-locking, interlocking and jogging working mode by short-circuiting the pin.
4. Learning type code: You can learn the code to the same frequency remote control at will. (Don't worry if you lose the remote control during the process. Just buy a remote control and learn it. )
Press and hold the learning button, the learning indicator will enter the learning state from on to off, press any button on the remote control to send a signal, and the indication flashes several times to indicate that the learning is successful.
Tip: This controller can learn multiple remote controllers with different codes. If it is exceeded, the first one will automatically clear.
Keep pressing the learning button, the indicator light turns from off to off and then on, indicating that the clear code is successful, it takes about 6 seconds.